Bar Screen Machine

1. The drive unit features of low noise, high efficiency and good sealing. The service life of the reducer should be over 10 years.

2. Shaft-mounted reducer for transmission, screw-type adjusting device is arranged on both sides of the frame to balance the tension of the transmission chain.

3. The reducer bearings are well lubricated and with service life over 100,000 hours. The gear service factor of the reducer is≥ 1.5

4. Low alloy steel and carburized gear, tooth surface hardness is no less than HRC58.

5.Working voltage is 380V, 3 phase, 50Hz, the protection grade is IP65, the rated power of the motor is 10% larger than the maximum power consumption, and the motor speed is not exceed 1500r/min.

b) Rack

1. One-piece rigid structure made of SUS 304 and structural steel, with sufficient strength and rigidity. No distortion occurs under the condition of 1.0m water level difference.

2. The rubber seals on both sides of the rack is used to prevent the rubbish passing the gap between the rack and tank wall

c) Traction chain and sprocket

The underwater guide rollers are reliable to prevent entanglement of dirt, such as grid slag.

d) Cleaning bar

1. 304 SUS material, the tooth-shaped structure meets smooth unloading, and returning bar after unloading is no adhere to dirt.

2. The rubber cleaning scraper is arranged for cleaning after discharging gums, and the driving of the cleaning scraper is driven by the main driving device.

e) Cover

Equip with closed stainless steel cover, which is openable ，convenient for daily maintenance and management.