MBR module installation precautions

1, the first thing to tidy up the installation environment when the film is installed, the film removed from the packaging can be placed smoothly, in the installation process may touch the film surface sharp blunt carefully wrapped up, to prevent the installation process to damage the film.

2. Ensure that the MBR module pool is clean and no particulate debris is left at the bottom of the pool, and the membrane component bracket is fixed and reliable. The MBR pool is then initially flooded with water about 10 cm above the top of the assembly. The surface of the new film just removed from the packaging bag is sticky. If you do not put good water to play a smooth role at the time of installation, the two film surfaces will stick together. If you press down hard, the film surface will be damaged.

3, just from the packaging plastic bag out of the diaphragm, the process of handling the diaphragm can not make the film surface has a large point of view bending, more can not be placed in the ground without protection measures or other objects above.

4. When each diaphragm is about to be installed after being unpacked, it is necessary to check the details, check whether there are scratches on the surface of each film, check whether there are empty glue joints if problems are found, the diaphragm should be replaced in time.

5, when assembling the diaphragm, try not to step on the diaphragm, if necessary, try to step on the corner of the film rather than the middle.

6. In the process of filling the film, the action should be slow to ensure that each film is in the corresponding partition, do not pull hard push.